If you have ever seen a really good rock show, you probably didn't notice the PA system. But chances are if the show was bad, it was the first thing you noticed. The way you set up a PA for a band can make or break the performance. When you set up for your show, you should know what you are doing. Here are guidelines for how to cover a simple setup using a small PA system in a small club setting.
Things You'll Need
- Microphones (One For Each Singer And Instrument)
- Power Amp (You May Need Two)
- Xlr Cables (One For Each Microphone)
- At Least Two Main Speakers
- Mixing Board
- Speaker Stands
- Monitor Speakers (At Least Two)
- 1/4" Speaker Cables (At Least Four Or Five)
Place everything where you want it to go. Don't worry about the cables yet. Assuming a small setup, place the main speakers to the left and right of the band, aimed slightly towards the center of the room. It is best to place them in an elevated position for the best sound projection.
Place one monitor speaker in the center of everything, facing the band. Monitors work well on the floor aimed up towards the players. The singer usually stands right in front of it, but you can aim it towards any player you want, or add more monitors as needed.
Put another monitor towards the back of the band for the drummer. This monitor will be for the drummer only.
Placement of the mixing board depends on who is running the sound for the show. If your band does its own sound, put the board where the band can reach it, but out of view of the audience. It is best, however to have the board and the sound guy out behind the audience.
Set up the microphone stands and microphones where you need them. Have one for each singer, one for each guitar, bass, and two for the drums if you have the resources. In a small club setting, you may not need microphones for the drums. Even with the loudest amplifiers, putting a mic on each instrument will allow you more control when it comes time to mix the sound.
Wiring It All Up
Check the output jacks of your board and look for "Monitor." Using a speaker cable, connect the monitor output to a power amp, and the power amp to each monitor. Some more expensive systems give you control over each individual monitor, and some boards actually have an on board power amp for the monitors. Know your equipment.
Again using the speaker cables, connect the main outputs on the board (right and left) to another power amp, then to the main speakers.
Run XLR cables from each microphone to the board, assigning a channel to each one. Label them or remember which one is which, so you don't accidentally turn up the wrong one.
Turn all the main volumes down on the board and power amps, and turn everything on.
Adjust the volume levels, do a sound check, get down and boogie.
Placing hardware first allows you to change things without tripping over wires.
Know your equipment before setting it up. Subtle variations between systems can throw you off if you aren't familiar with them first.
Always start with all volume levels all the way down to avoid blowing speakers and overloading amplifiers. If you put the board behind the audience, have someone with it at all times, or it may end up getting damaged by curious fingers.
Sandi Stritch specializes in alternative health and mental-health topics. She has more than five years experience working in a psychiatric hospital. Valentine began writing online in 2007 with pieces appearing in "The Main ARTery" and "In the Panhandle." She holds a Bachelor of Arts in psychology from Shepherd University.