How to Make Your Own Cribbage Board

By Mike Parker

Cribbage is one of the most enduring of all card games, dating as far back as the seventeenth century, evolving from a much earlier English game called Noddy. Sir John Suckling, a wealthy English poet is credited with creating the game in its modern form. While it is possible to keep score in cribbage with pencil and paper, it is far easier to use a cribbage board. This board can be quite simple or extremely ornate, but all cribbage boards have four rows of 30 holes each, divided into two pairs of rows by a central panel. Four additional game holes are usually found near one end of the board. Although cribbage boards are readily available for purchase, if you have a steady hand with a drill you can make one that is uniquely your own.

How To Make Your Own Cribbage Board

Design your Cribbage Board template using graph paper. Insure the length and width of your design does not exceed the dimensions of your Cribbage Board.

Trim the width of the template to 4 inches wide. Tape the template securely to the cardboard. Mark the holes through the template into the cardboard with the awl. Tape the cardboard with the template securely to the hardwood.

Chuck the bit securely into the drill. Mark the bit ½ inch from the tip with tape. Drill each marked hole through the template into the hardwood, stopping at the tape mark.

Remove the cardboard and template from the hardwood. Sand the edges of the hardwood board and around the peg holes lightly. Wipe any dust from the board with the cloth.

Seal the peg holes with the wood-burning tool by using a wide tip and pushing it up and down inside each hole. Burn any desired design into the wood. Spray on the polyurethane to seal the board. Allow the polyurethane to air dry before using the cribbage board.